798646e1

4.1.4. Removal and installation of a final collector

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Working under the car, give bolts of fastening of a reception pipe of system of production of the fulfilled gases to a final collector. Disconnect a pipe from a collector.
  3. Remove the air duct passing between the air cleaner and a cyclonic pyleotdelitel of preliminary cleaning.
  4. Give fixing bolts and remove the thermofilter from a final collector. Remember a point of connection of the tire of grounding.
  5. Moving on a spiral outside inside, gradually weaken fixture of a final collector.
  6. Remove fixing bolts, nuts and their washers and take assembly of a final collector from a motive compartment (see an accompanying illustration).
1 — the thermofilter
2 — a final collector
3 — laying
  1. Check the interfaced surfaces of a final collector for existence of cracks, deformations and other damages. Execute necessary repair, or replace a collector.

Installation

 PERFORMANCE ORDER

  1. Installation is made upside-down.
  2. Do not forget to smooth out previously carefully interfaced surfaces and to replace all laying.
  3. Do not forget to establish under washer fixture. Tighten fixture with the required effort, moving on a spiral from within outside.
  4. At installation of the thermofilter do not forget to connect the grounding tire.

In order to avoid a prikipaniye and for the purpose of ensuring further maintainability of the equipment grease fixture carvings before installation by the suitable anti-taking sealant.

  1. Start the engine and check a collector for leak of the fulfilled gases