2.16. Diagnostics of malfunctions of onboard electric equipment
Lighting fixtures
Functioning of lamps/lamps is broken
The lamp(s) is faulty. Check, replace a defective lamp.
The break of an electrical wiring takes place, or the contact was disconnected. Check a lamp power-supply circuit, execute necessary repair.
The switch of the lighting fixture is faulty. Check, in case of need replace.
The safety lock failed, or its block is faulty.
The relay of the lighting fixture is faulty. Replace the relay.
Brightness of a luminescence of lamps/lamps is broken
Grounding of lamps/lamps is incorrectly executed. Check reliability of fastening and a condition of plugs of grounding, both on the lamp case, and on a wire. Execute necessary repair.
Lamps not of that of nominal capacity/tension are established. Check, in case of need replace.
The reflector is polluted or damaged. Wipe a reflector, or replace it.
The lamp is faulty. Check by substitution obviously serviceable, in case of need replace.
The lens is polluted. Wipe, or replace.
The increased resistive resistance in a chain between the generator and the battery takes place, or terminal connections are faulty. Check, execute necessary repair.
Quality of electric connections in a chain between the battery and the engine or the generator is broken. Check a condition of a wire of grounding of the battery and tire of grounding of the engine for the chassis.
Tension regulator is faulty. Replace the defective block.
|
|
Most often decrease in intensity of a luminescence of lamps is connected with pollution or oxidation of plugs of wires of grounding. Smooth out all terminal connections, check a condition of an electrical wiring. |
Indexes of turns
The lamp of the index does not function and clicks of the breaker are not heard
The safety lock fused. Remove the cause of an overload and replace a safety lock.
| The breaker is faulty. Replace. Location of the breaker is shown on an accompanying illustration. |
The switch of indexes of turns is faulty. Replace.
Defect of an electrical wiring takes place. Check, execute necessary repair.
The lamp of the index does not function, but clicks of the breaker are clearly heard
The control lamp of the corresponding index fused. Check, replace.
The electrical wiring of a control lamp is faulty. Check, execute necessary repair.
|
|
When replacing lamps you watch compliance of their electric parameters to technical requirements (see size tables and adjustments at the end of the Management). |
The lamp of the index of turn burns low and blinks with the increased frequency
The breaker is faulty. Check, rumple the defective block.
The lamp of the forward or back index from the relevant party of the car fused. Check, replace a defective lamp.
|
|
When replacing the breaker install only branded blocks. |
The alarm system does not function
The breaker failed. Check, replace the defective block.
The switch of the alarm system is faulty. Replace.