12.7.3. Removal and installation of a steering wheel
|
|
Removal of the helmsman will require a special stripper. |
Removal
|
|
- Disconnect a negative wire from the battery.
- On models with the central arrangement of the button of a horn carefully hook the button sideways by means of the tool with a flat sting and remove it from a wheel (see an accompanying illustration).
- On models with screw fastening of the button of a horn by means of the short screw-driver give fixing screws under a steering wheel.
- Disconnect an electrical wiring from the button.
- Mark the provision of a steering wheel on a shaft, then give a fixing nut.
- By means of a special stripper remove a wheel from a steering shaft.
|
|
|
|
You do not knock on an end face of a steering shaft as it is fraught with damage of a column. |
Installation
Installation is made upside-down.
|
|
- Grease with universal lubricant a returnable cam of the switch of indexes of turns from the back party of a steering wheel.
- Achieve combination of the adjusting tags put in the course of dismantle and put a steering wheel on a shaft.
- Check serviceability of operation of the returnable mechanism of the switch of indexes of turns and tighten a nut of fastening of a steering wheel with effort of 29 ÷ 39 Nanometers.
|
|
