12.5. Back suspension bracket of spring type
Service of shock-absorbers
Removal and installation
Removal
|
|
- Car back also establish to Poddomkratta it on the props got under a case of the back bridge.
- Give a nut of fastening of the top end of the shock-absorber to the car chassis. Remove washers and rubber plugs (see an accompanying illustration).
- Give a nut of fastening of the lower end of the shock-absorber to a basic plate of a spring. Remove washers and rubber plugs.
- Remove the shock-absorber from the car.
|
|
Installation
Installation is made upside-down.
|
|
- Track correctness of installation of rubber plugs and washers of fixture.
- Track correctness of installation of the shock-absorber. The dustproof coupling has to be turned down and put on the lower end of the shock-absorber.
- Tighten the top fixing nut with effort of 47 ÷ 65 Nanometers, lower - with effort of 17 ÷ 23 Nanometers.
|
|
Check and pumping
|
|
The description of procedures of check of a condition of the shock-absorber which implementation does not require the special equipment is given below. |
|
|
- Examine the shock-absorber case on existence of dents, other damages and traces of leaks. The defective shock-absorber is not subject to recovery repair and has to be replaced.
- Check a condition of rubber plugs, in case of need make replacement.
- Clamp the shock-absorber vertically in a vice (for a finger of the lower support).
- Undertake the top part of the shock-absorber and, having pulled, lift it against the stop up, then slowly lower down, having completely squeezed the shock-absorber.
- Repeat the procedure of the last paragraph six-eight times, having completely eliminated the side plays determined by the air which is present at the shock-absorber. If side plays are not eliminated, the shock-absorber has to be replaced.
|
|
