798646e1

9.2.3. Service of the sensor switch of permission of start

Check of serviceability of functioning

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Disunite the electric socket of the sensor switch of permission of start.
  1. Check existence of conductivity between socket plugs at various provisions of the lever of the selector (see an accompanying illustration).
  1. If conductivity is absent in all checks, disconnect draft of the selector from the lever and you povrit the procedure.
  2. If check yields positive result, adjust draft of the selector.
  3. At negative results of check remove the sensor switch of permission of start from transmission and repeat check once again.
  4. If this time everything appears as it should be, install the sensor switch into place and adjust it as below in this Section is described.
  5. If conductivity is still absent in all cases replace the sensor switch of permission of start.

Removal and installation

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  1. Disunite the electric socket of the sensor switch of permission of start (appearance of the sensor switch is shown on an accompanying illustration).
  1. Transfer transmission to situation I, give fixing bolts and remove the sensor switch of permission of start from transmission.

Installation

Installation is made upside-down.

 PERFORMANCE ORDER

  1. Track quality of electric contact of plugs of the socket and reliability of fastening of the last.
  2. Execute adjustment of the sensor switch.

Adjustment

 PERFORMANCE ORDER

  1. Give a lock-nut of draft of the selector and disconnect draft from a selector rod.
  2. Transfer a selector rod to situation "N".
  3. Weaken bolts of fastening of the sensor switch of permission of start.
  4. Enter a core of ø of 4 mm into an opening in a selector rod.
  5. Modify position of the sensor switch so that the core got to an opening in it. You hold a core whenever possible perpendicular to the sensor switch.
  6. Tighten bolts of fastening of the sensor switch.
  7. Connect thirst of the selector for a rod, screw a lock-nut and make draft adjustment as it is described below.