- Warm up transmission up to the normal working temperature, the car and install to a poddomkratta it on props so that the pallet of a case of transmission reached horizontal position.
- Establish drain capacity under the transmission case pallet and give back bolts of fastening of the pallet to a case.
- Give side bolts of fastening of the pallet, having left screwed only lobbies.
- Weaken the remained bolts, incline the pallet and merge transmission liquid in the prepared capacity.
|
|
Try not to burn - liquid will be hotter! |
- Turn out forward fixing bolts and remove the pallet from a case. You will throw out laying.
- Wash out the pallet solvent and check it for existence of deposits of material of frictional overlays of disks of the converter or brake tapes.
|
|
In case of identification of traces of this sort of deposits address for consultation specialists of dealer office of the manufacturing company. |
- Smooth out the interfaced surfaces of the pallet and a case of transmission. Check existence of a magnet in the central part of the pallet.
- Install the pallet with new laying and in a diagonal order tighten fixing bolts with effort of 5 ÷ 8 Nanometers.
- Fill in in transmission necessary amount of oil of the required grade (approximately as much how many it was merged).
- Start the engine and let's it work within about three minutes on single turns.
- Slowly carry out the selector lever through all provisions, having in conclusion returned it to an initial ("R").
- At the engine working at single turns check the level of transmission liquid.
- Examine transmission on existence of signs of leaks and make trial runs of the car for a guarantee of high-quality warming up of transmission and the engine.
- At the engine working at single turns (transmission in situation "P") repeat check of level of transmission liquid, in case of need make addition.
|
|
Смотрите ecrane.ru liebherr ltm 1160.