14.9. Service of screenwashes
Removal and installation of brushes
|
|
- Lift the screen wiper lever in the fixed vertical position, having taken away it from glass.
- Release a clip of a clamp and remove a brush from the lever.
- Installation is made upside-down. Track reliability of a zashchelkivaniye of a clamp.
|
|
Replacement of working elements of brushes
|
|
- Remove a brush from the lever.
|
|
- Grasp an elastic band of a working element since the basic end and pull it, releasing from a clamp on a brush. Moving sideways, remove an element from a brush (see an accompanying illustration).
|
- Dress a steel sled on a working element and pass it through brush clips, having rested against a face clamp.
- Grease the end of an element and densely latch it in a face clamp of a brush.
- Install a brush on the lever.
|
|
Removal and installation of levers of screen wipers
Removal
|
|
- Remove a protective cover from a fixing nut of the lever.
- Give a nut of fastening of the lever to an axis.
- Having carefully hooked, remove the lever from an axis (see an accompanying illustration).
|
|
Installation
Installation is made upside-down.
|
|
- Transfer the driving motor to parking situation and level brushes, having arranged them in 20 ÷ 30 mm over a sealing tape of a windshield.
- Strongly tighten a nut.
|
|
Removal and installation of an electric motor of the drive of screen wipers
Removal
|
|
- Disconnect a negative wire from the battery.
- Disunite the electric socket of the motor.
|
|
- Give fixing bolts (see an accompanying illustration) and partially take the motor from a partition.
|
- Disconnect draft from the lever of the motor and remove the last from the car.
|
|
Installation
Installation is made upside-down.
|
|
- Track reliability of fastening of draft on the motor lever.
- Strongly tighten all fixture.
- Check a condition of contacts and reliability of fastening of the electric socket.
|
|
Removal and installation of draft of the drive of screen wipers
|
|
- Remove levers of screen wipers.
- Give fixing screws and remove the panel of a forward fairing from the car.
- Give bolts of fastening of axes of levers of screen wipers.
- Disconnect draft from an electric motor.
- Take draft through an opening under the fairing panel.
|
|
Installation is made upside-down.
