798646e1

14:11. Safety locks, fusible inserts and relay

Check of a state and replacement of safety locks

For replacement of the failed safety lock use only corresponding to it on nominal current (see marking on the safety lock case). Installation of the safety lock calculated on higher current it is fraught with damage of an electrical wiring and ignition.


The assembly block of safety locks of models with right-hand steering is located under the right corner of the dashboard (see an accompanying illustration).


 PERFORMANCE ORDER

  1. Uncover the assembly block and study information given on it for definition of location of safety locks of protection of various contours.
  2. Take a safety lock from a nest in the block and visually check its state.
  3. In the absence of external signs of damage check a safety lock for existence of conductivity by means of an ohmmeter or a lamp sampler.
  4. Replace the failed safety lock on corresponding to it in parameters.
  5. If after replacement of a safety lock the contour still does not function, or the new safety lock at once fails, it is necessary to check a chain for existence in it of short circuit, or to address for consultation the qualified electrician.

Check of a state and replacement of fusible inserts

For replacement of a fusible insert use only inserts of company production and the same parameters. Installation of the insert calculated on higher current it is fraught with damage of an electrical wiring and ignition. The new fusible insert has to be established only after examination and elimination of the reason of failure of old.

The main fusible insert (i) is located on an arm near the rechargeable battery (see an accompanying illustration).

 

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Disconnect a fusible insert.
  3. Check an insert for existence of external signs of an overheat.
  4. At a working external order check an insert for existence of conductivity by means of an ohmmeter or a lamp sampler.
  5. Replace the failed insert new, connect the battery and check serviceability of functioning of the corresponding contour.
  6. If the contour still functions, or the new insert immediately fails, it is necessary to check a chain for existence in it of short circuit, or to ask for the help the professional electrician.

Location of the relay

Relays of systems of electric equipment are located in various points of the car.


Relays auxiliary accessories, systems of ignition and heating are located in the assembly block of safety locks. Other relays are fixed in a metal cover near the battery (see an accompanying illustration).

Identification of location of each relay is put on a reverse side of a cover.

The timer of blocking of doors, the breaker of a contour and the relay of the electric drive of window regulators are located behind a ware box.