13:17. Removal and installation of the dashboard
Removal
|
- Disconnect a negative wire from the battery.
- Remove a steering wheel.
|
You do not knock on an end face of a steering shaft the hammer in order to avoid damage of a steering column. |
- Give fastening screws to each other of two half of a casing of a steering column. Remove casings from a column.
|
- Give fixing screws and slightly delay facing of a combination of devices back (screws are shown by shooters on an accompanying illustration). Release electric sockets of switches and potentiometers and completely remove facing.
|
- Give fixing screws, partially take a combination from the dashboard and disconnect an electrical wiring from its back part. Remove a combination, watching to damaging protective glass.
- Give fastening screws to a basic arm of driving cables of opening of a cover of the hatch of a mouth of the gulf of fuel, a cowl and (if it is provided) shutdown of the stabilizer of cross stability.
|
- Give screws of fastening of a basic arm of driving cables (see an accompanying illustration), shift an arm back and remove it from the car.
|
- Disconnect a cable of the manual drive of a butterfly valve from the accelerator pedal and an arm.
- Open a cover of a ware box and give screws of fastening of the last. Remove a ware box from the car.
- Take an ashtray and give the screws located under it.
- Give screws of fastening of the central part of the dashboard.
- Transfer a control lever the transfer case to the provision of the lowering transfer and partially take the central part of the dashboard. Disconnect an electrical wiring of hours, the lighter, illumination of an ashtray, the switch of the alarm system, and also the other additional equipment.
- Remove the central part of the dashboard.
- Give fixing screws, partially take the radio tape recorder and disconnect from it an electrical wiring and an antenna cable. Remove the radio tape recorder.
- Remove handles from control levers a heater. By means of the screw-driver release fixing uvulas of the control panel of a heater. Remove the panel.
- By means of the screw-driver with a flat sting remove finishing slips by the top part of the dashboard (see an accompanying illustration - are shown by shooters).
|
- Give the bolts located along the upper edge of the dashboard, on each side and on bottom edge of an opening under installation of the radio tape recorder (are shown by shooters on an accompanying illustration).
|
- Release a cable of the drive of recirculation/supply of fresh air from a basic lath of a loop of a ware box.
- Carefully remove assembly of the dashboard from the car.
|
|
|
At removal of the dashboard by forces of one person also removal of the combined switch perhaps will be required. For this purpose it is necessary to give the fixing screw and to disunite electric sockets then it is necessary to push the switch down and to turn it on a quarter of a turn. |
Installation
Installation is made upside-down.
|
- Track correctness of laying of an electrical wiring.
- Check serviceability of functioning of the drive of management of a heater, in case of need execute adjustment.
- Strongly tighten all fixture.
- Check serviceability of functioning of all components which were removed or disconnected in the course of dismantle.
|
|