798646e1

4.2.5. Removal and installation of a final collector

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Working under the car, give bolts of fastening of a reception pipe of system of production of the fulfilled gases to a final collector. Disconnect a pipe from a collector.
  3. Give fixing bolts and remove the thermofilter from a final collector. Remember a point of connection of the tire of grounding.
  4. Pipe key disconnect EGR tube from a final collector.
  5. Moving on a spiral outside inside, gradually weaken fixture of a final collector.
  6. Remove fixing bolts, nuts and their washers and take assembly of a final collector from a motive compartment.
  7. Check the interfaced surfaces of a final collector for existence of cracks, deformations and other damages. Execute necessary repair, or replace a collector.

Installation

Installation is made upside-down.

 PERFORMANCE ORDER

  1. Do not forget to smooth out previously carefully interfaced surfaces and to replace all laying.
  2. Do not forget to establish under washer fixture. Tighten fixture with the required effort, moving on a spiral from within outside.
  3. At installation of the thermofilter do not forget to connect the grounding tire.
  4. Start the engine and check a collector for existence of signs of leak of the fulfilled gases.