12.6.6. Removal and installation of assembly of the mechanism of shutdown of the back stabilizer of cross stability
Removal
Components of the drive of shutdown of the back stabilizer of cross stability
|
|
- Car back also establish to Poddomkratta it on the props got under a bridge case. Transfer the handle of management of shutdown of the stabilizer of cross stability to situation "Is included".
- Give a nut of the spherical hinge of the right rack of the stabilizer of cross stability and disconnect a rack from a bar.
- Disunite the electric socket of a control lamp.
- Disconnect a forward driving cable from back on the regulator. By means of flat-nose pliers remove a lock plate of a cable on an adjusting arm.
- Give coupling bolts of a cable and release assembly fastening bolts. Take assembly of shutdown of the stabilizer of cross stability from under the car.
- In case of need it is possible to remove a forward driving cable with the handle of management for what:
- Give coupling bolts of fastening of a cable to the car chassis.
- Give nuts of fastening of the handle of management to a partition.
- Turn out a bolt of fastening of the handle to the dashboard, remove the handle with a cable from the car.
- Check assembly of shutdown of the stabilizer of cross stability for existence of signs of damages. Pull a driving cable of assembly by a hand, checking serviceability of shutdown of a rack of the stabilizer. At a cable otpuskaniye the rack has to be blocked strongly in assembly. In case of need make replacement.
|
|
Installation
Installation is made upside-down.
|
|
- Adjust cable length, trying to obtain the size of a free wheeling in 0.2 ÷ 0.7 mm.
- Make sure of reliability of fastening of the socket of a control lamp.
|
|
