798646e1

12.6.5. Removal and installation of the stabilizer of cross stability

Removal

 PERFORMANCE ORDER

  1. Car back also establish to Poddomkratta it on the props got under a case of the back bridge.
  2. Give nuts of fastening of racks of a bar to arms of the chassis and remove washers and rubber plugs (see an accompanying illustration).
1 — a nut
2 — a washer
3 — the rubber plug
4 — a rack
5 — a stabilizer bar
6 — a rubber pillow
7 — bolts
8 — an arm

On the models equipped with the mechanism of shutdown of the back stabilizer of cross stability the right rack is a shutdown mechanism detail. Procedures of removal and installation of assembly of shutdown of the stabilizer of cross stability are described in the following Section (Steering).

  1. Give nuts of spherical hinges of racks of the stabilizer of cross stability and remove racks from the car.
  2. Give bolts of fastening of basic arms of a bar of the stabilizer of cross stability to a case of the back bridge. Remove arms from the car.
  3. Take a bar of the stabilizer of cross stability from under the car.

Installation

Installation is made upside-down.

 PERFORMANCE ORDER

  1. Check a state and track correctness of landing of rubber pillows in arms. Tighten fixing bolts with effort of 25 ÷ 32 Nanometers. At the correct tightening of bolts the tags put with paint on a bar of the stabilizer of cross stability have to act evenly on both sides.
  2. Check a condition of rubber plugs and spherical hinges of racks of the stabilizer of cross stability, track correctness of landing of components. Tighten nuts of spherical hinges with effort of 25 ÷ 32 Nanometers.