798646e1

6.1.6. Service of a cable of the drive of a butterfly valve

Removal and installation

Removal

 PERFORMANCE ORDER

  1. Weaken lock-nuts and take a cable from an adjusting arm.
  1. Turn of the lever transfer a butterfly valve to completely open situation. Using the formed weak point, disconnect a cable from the lever.
  2. In interior of the car release uvulas and remove the plastic plug of a cable from the top part of the lever of the accelerator pedal. Release the cable core from the lever.
  3. Give bolts of fastening of an arm of a cable.
  4. Involve a gas cable through a partition of a motive compartment in interior of the car.
  5. Check the core and a cover of a cable for existence of signs of wear, damage of a carving and a peg. In case of need replace a cable.

Installation

Installation is made upside-down.

 PERFORMANCE ORDER

  1. In order to avoid education a peg try not to twist a cable and not to bend it too strongly.
  2. Track correctness of installation of the plastic plug in the top part of the lever of the accelerator pedal.

Adjustment

 PERFORMANCE ORDER

  1. Make sure that the cable of the manual drive of a butterfly valve is completely released.
  2. Ask the assistant to squeeze out completely the accelerator pedal and make sure that draft of the drive of butterfly valves is in the provision of full opening.
  3. In case of need weaken lock-nuts and as appropriate correct cable length.
  4. At the correct adjustment the throttle has to be completely open at the accelerator pedal which is squeezed out to a floor.
  5. The released pedal has to have a free wheeling of 1 ÷ 3 mm. Also the cable core on draft of the drive of butterfly valves on the carburetor has to have an insignificant weak point.