12.3.2. Removal and installation of screw springs of a forward suspension bracket
|
|
Implementation of the procedures described below will require the special tool for compression of screw springs. |
Removal
Components of a screw spring of a forward suspension bracket
|
|
- Car front also establish to Poddomkratta it on the props got under a chassis frame.
- Give bolts of fastening of a cover of the limiter of the course of compression, uncover.
- Turn off a nut of fastening of the limiter of the course of compression and leave the limiter operty in the lower saddle of a spring.
- By means of the special tool squeeze a screw spring so that the possibility of its removal appeared.
- Remove a spring, the limiter of the course of compression and the top rubber insulator from the car.
- Examine a spring on existence of cracks, signs of deformation and easing of the developed effort. Whenever possible compare spring length to new.
- Check the compression course limiter for existence of damages and signs of aging of material.
|
|
Installation
Installation is made upside-down.
Track that the top saddle of a spring was the located correct image, the limiter of the course of compression got in a spring.
