798646e1

11.7. Service of a pedal of a brake

Removal and installation

Removal

 PERFORMANCE ORDER

  1. Remove a fixing clip, squeeze plastic lock uvulas, take a finger and disconnect a pusher from a brake pedal.
  2. Try to remember the adjusting provision of a returnable spring of a pedal, give a nut of an axial bolt, take a bolt from a basic arm and remove a pedal from the car (components of a pedal are shown on an accompanying illustration). Check a pedal for existence of cracks and signs of deformation. Execute necessary repair or rumple a pedal.
1 — a bolt
2 — the plug
3 — a pedal
4 — a spring
5 — a washer
6 — a nut
  1. Check axial plugs of a pedal for existence of signs of wear and damages. Check the effort developed by a returnable spring. Replace defective components.

Installation

Installation is made upside-down.

 PERFORMANCE ORDER

  1. Track that the pedal at an otpuskaniye came back to the same situation, as before removal.
  2. Tighten a nut of an axial bolt with the required effort.
  3. Check installation of height of situation and size of a free wheeling of a pedal, in case of need execute adjustment.

Adjustment of height of situation and size of a free wheeling of a pedal of a brake

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Disconnect an electrical wiring from the sensor switch of stoplights.
  3. Weaken a lock-nut on two stoplights and turn the sensor switch counterclockwise, having taken away it from a pedal.
  4. Weaken a lock-nut of a tip of a pusher and adjust length of the last, trying to obtain the required height of provision of a pedal (see size tables and adjustments at the end of the Management). Measurement is performed from the floor panel to a surface of an overlay of a pedal (A) on an accompanying illustration.
1 — a pusher
2 — a fixing finger
3 — the sensor switch of stoplights
4 — a lock-nut
5 — a pedal
6 — an overlay of a pedal

Measurement is performed at the removed rug! Tighten a pusher tip lock-nut.

Track that upon completion of adjustment the tip did not descend from a pusher rod.

  1. Adjust position of the sensor switch of stoplights so that the gap between edge of a carving part of the sensor switch and a pedal (In - see an accompanying illustration) made 0.3 ÷ 1.0 mm. Tighten a lock-nut of the sensor switch and check the size of a free wheeling of a pedal (see size tables and adjustments at the end of the Management).
  2. In case of need correct position of the sensor switch, trying to obtain the required size of a free wheeling. Make sure that stoplights do not burn at the released brake pedal.